Відео

What is the emergency code please tell me

If the read / write / verify is bad on the memory chip then you can check the voltage the CH-341 programmer is providing, it might be weak. In that case just feed external voltage 5V or 3.3 V or whatever the chip need directly to the programmer from your bench power supply.

Samsung panel is very weak...

3 red light ?

What temperature soldering iron did you use to melt the soldering iron on the motherboard.?

I'm a little confused. Can we just replace the cable rather than do this tape method? Would it work?

How can I do this

ua-cam.com/video/aI8yr_GjedE/v-deo.htmlsi=R6FSNpTkqP8G5Bd6

Use ps2 to hdmi converter in ps3. Watch some indonesian video.

if a customer says to me it's just a fuse issue, I give him a fuse, and I say if your device burns or explodes, don't come back to repair it

😢just cut the ck lines only

Thank you

After taping it works but the problem comes back again after couple days. What would you do in this situation?

Thank you so much

Hey, where can I find the replacement piece?

i like the video ,but i dont get why covering with tape/cutting the lines makes the set work? can you explain ?

thank you very much for the good tutorial sir..

Thanks sire, that's sure worked 🔥

Hi have same problem with my noco can i send it to you ?

Je crois que tu as oublié la petite éponge à l'intérieur ... mais bravo pour le Job ! Excellent 🤩

Khoya fen sakn?

Hello, on my Samsung TV I have no voltage on capacitor near ribbon cable on mainboard. When I disconnect ribbon cable and make a bridge on the 2 points at the top right corner on mainboard I have 17v on capacitor. What could be the problem ? No shorted capacitors on drivers panel. Thank you for any help

What size diode is that?

Forget my pin code Samsung Galaxy A14 airplane mode

Legend. Ty

LEDs in these TVs are designed to die after 1-3 years..since leds are supposed to last 20 years, manufacturers use downgraded leds to rip off consumers..much like the cascadent bulb story.

Man, was about to throw this TV out. You’ve saved so TVs. Mine is working as good as new. Thank you!!

Where can i find a replacement battery for the gbx75?

So to fix you just removed the capacitor? Didn't replace it?

Exact same unit I had last week, same problem - both belts. Easy fix. It took me longer to figure out how to open it. Make sure you have an Audio CD laying around to test with!!🤣🤣🤣🙃

Another good repair. Well done...

Tengo uno igual pero no regula +15 V y -15V esta dañado un smd 1Bt y nececito el schematic los modulos de poder estan bien pero el preamplificador no finciona

I love my unit...only had to replace the battery once and they're cheap. Only complaint for me is the fact that I can't get many radio channels, but that's not much of a surprise considering that I live in the Sierra foothills...

great work

Hi I have same wave radio for repair it's working but d problem is cd doesn't work tried changing capacitor but sitt d Sam what could be d problem?

This worked for me also. Thank you!

That’s why there’s only 1 year warranty because they’re not meant to last

They are not fuses, they are ferrite beads. They can act like a fuse just like a 0 ohm resistor can. They are designed to filter high frequency noise. You tested for ground at that cap, why would you replace with a ferrite bead? Also you should invest in some smart tweezers. You could have grabbed that cap after it was off and measured its capacitance and esr. It would have saved you hours and 3 driver ic’s.

Hi bro by mistake my czn water spray on my controller but i did not know he spray water on my controller i play games without any problem after some time some button not working r2 psbutton i see water only on buttons or little drops on film i clean it ps button start working but r2 not working after some time ps button stop working charging light change to red but everything working prefect touchpad motors joystick charging but it does not charge with wall charger i order new film and put the controller in the daraz after two days when i plug it with the cable it is not working or charging no light come can replace conductive film fix it. It clean it reset it but not working

How do I know what diode to buy. I’d like to order some assortment of diodes

Good job! Sharp T'V's are a pain in the you know what. Just repaired a 60" that ran me in circles.

friend can you recommend a good type of solder and flux to use for soldering circuit board ?

Love this

DO WE HAVE TO LISTEN TO U OR TO THE RADIO U R LISTENING

Great job figuring it out. I just got my first CD player repair in the other day, a Sony 5 cd player. The repair was easy but when I went to test I realized I was missing a tool to test it with ...an Audio CD 🙄🤣🤣 I've been using Amazon Music too long, I guess.🙃

Thanks very much 🙏🙏🙏🙏🙏🙏🙏🙏🙏

Twisting may cause print damage

Very nice repair, this could have been one of those devices that takes hours to figure out. You made troubleshooting a device like this look easier than it really is.

watching master

Nice video! Hoping you make one on my fix as well 😁! Keep it up brother !